Overview
The Omix-ADA 16584.11 is a differential bearing cap bolt, and two are needed for each bearing cap. It fits the 1999-2001 Jeep Cherokee (XJ), the 1999-2003 Jeep Grand Cherokee (WJ) and the 2003-2006 Jeep Wrangler (TJ) Rubicon. These bolts hold each cap in place so it seats correctly.
The bolts are built to original specifications and carry a direct fit. Count the bearing caps in your differential before ordering.
Key features
- Differential bearing cap bolt, part 16584.11
- Two bolts required per bearing cap
- Built to original specifications
- Direct fit
Installing bearing cap bolts correctly
Bearing cap bolts hold the caps that support the differential carrier bearings, so their job is to keep the carrier aligned under load. A bolt that stretches or loses clamp force can let the cap shift, which changes bearing preload and can damage the carrier.
Before installing, clean the threads and the bolt seats in the housing and cap. Check that the cap sits square against the housing before the bolts are fully tightened, and tighten them in an even pattern. Bolts that show corrosion, rounded heads or damaged threads should be replaced as a pair.
Carrier setup and bearing preload should be checked after the caps are torqued. Recheck the bolts after the first few drives, as settling can slightly reduce clamp force.
- Clean threads and bolt seats before fitting
- Tighten in an even pattern once the cap is square
- Replace bolts with damaged threads or corrosion
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16584.11 |
| UPC | 804314131814 |
| Part type | Differential bearing cap bolt |
| Quantity | 2 per bearing cap |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1999-2001 Jeep Cherokee (XJ) in Classic, Limited, SE and Sport trims, the 1999-2003 Jeep Grand Cherokee (WJ) in Laredo, Limited, Overland and Sport trims, and the 2003-2006 Jeep Wrangler (TJ) Rubicon.
The Cherokee years are 1999-2001 and the Grand Cherokee years are 1999-2003, so the earlier XJ and ZJ models are not covered. The Wrangler entry is for the Rubicon only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tighten the bearing cap bolts to the correct specification after the cap is seated. Check the cap alignment before fully tightening.
What’s included
Differential bearing cap bolts at the quantity of two per bearing cap.
Not included: Bearing caps and bearings are not part of this kit.







