Overview
The ARB RD153 is an 8.9 inch C-clip air locking differential for Toyota rear axles with 30 splines. The air-activated locker joins both axle shafts, so a rear differential that normally sends power to one wheel delivers it to both.
Toyota C-clip axles are the intended application here. The specifications give two different axle sizes, so measure your axle diameter and spline count before choosing the unit.
Key features
- Air-activated selectable locker
- C-clip design for Toyota rear axles
- Changes an open differential into a full spool axle
- 30 spline configuration
How a selectable locker behaves
A selectable locker sits inside the rear differential and stays open until you engage it. An open differential sends torque to whichever wheel has the least grip, so a spinning tire can leave the vehicle stuck even when the other tire still has traction. Engaging the locker ties both axle shafts together, which helps on loose gravel, rock steps and off-camber climbs. Full spool operation is most useful at low speed and should be released on pavement, where tires can scrub during tight turns.
Fitting a locker is often paired with a check of the axle bearings, seals and shaft retention, since the locker places the same load through both shafts. Keep the air supply lines clear of moving parts and inspect them after the first few engagements. Gear oil should also be checked and replaced at the oil grade the unit requires.
- Check axle seals and bearings during the swap
- Inspect the carrier for wear before installing
- Keep air lines clear of suspension and driveline parts
- Look for leaks at air fittings after the first engagement
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD153 |
| UPC | 88134801228 |
| Differential type | Selectable locker, air activated |
| Axle manufacturer | Toyota |
| Axle location | Rear |
| Axle type | Toyota 9.5 Inches |
| Diameter in title | 8.9 Inch C-Clip |
| Axle spline count | 30 splines |
Vehicle fitment
The axle type is Toyota 9.5 inch, and the unit is 8.9 inch C-clip, so measure your axle before checking fit.
Other Toyota axle sizes and clip styles are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the axle diameter and count the 30 splines first, since the two size entries differ. Arrange the air supply in advance, because the locker runs on compressed air from a separate onboard compressor.
What’s included
The C-clip air locking differential is what this part number covers. Not included: the air compressor needed to activate the locker.







