Overview
The Moog ES800762 is a front outer tie rod end for the 2007–2010 Hummer H3 and the 2009–2010 Hummer H3T. It is sold individually and is a direct-fit replacement.
Moog says tie rods are a crucial part of the steering system: when the steering wheel is turned, the motion travels through the steering rack, through the tie rods and finally to the steering arm or spindle. The company builds its tie rods as forged one-piece units, in contrast to the two-piece assemblies on many original parts, and protects them with a neoprene-sealed rubber boot that resists heat, cold and abrasion. A small valve in the boot allows old grease and contaminants to be flushed out, and the hardened full-ball metal studs are described by Moog as more durable than the original equipment.
The H3 and H3T are the two vehicles named for this tie rod end, so the part number is a single answer for Hummer owners who need a front outer replacement on either truck.
Key features
- Front outer tie rod end
- Sold individually
- Forged one-piece design
- Neoprene-sealed rubber dust boot with a grease flushing valve
- Hardened full-ball metal studs
- Direct fit for Hummer H3 and H3T
Replacing tie rods on both sides
Outer tie rod ends carry the sideways steering load between the steering linkage and the wheel, and they wear first at the stud and the boot. Common signs of a worn end include play or a clunk when turning, a wandering steering wheel, and tire wear on the outer edge of the tread. Because both front sides share the same loads, a worn end on one side is a good reason to look at the other side too.
When a tie rod end is replaced, it is common to inspect the steering arm, the inner joint and the rest of the linkage at the same time, since a worn part elsewhere can make a new end wear faster. Keep the boot clean and check it for cracks before fitting. Tighten the nut to the torque given in the service information for your vehicle.
- Play or clunking when turning
- Steering wheel off-center or pulling
- Uneven or edge tire wear
- Torn or cracked boot
Specifications
| Brand | Moog |
|---|---|
| Part number | ES800762 |
| Product | Front outer tie rod end |
| Quantity | Sold individually |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Studs | Hardened full-ball metal |
| Fitment type | Direct fit |
Vehicle fitment
The ES800762 fits the 2007–2010 Hummer H3 in Alpha, Base, Championship Series and X versions, and the 2009–2010 Hummer H3T in Alpha and Base versions.
The H3 and H3T are the only vehicles listed, and the H3T listing starts in 2009, so other Hummer models are not covered. Moog lists both versions of the Hummer in Alpha and Base trim, with the H3 also available as Championship Series and X. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
An alignment is the follow-up Moog asks for after any tie rod replacement. Since the part is sold individually, a vehicle needing both sides replaced will need two. The boot has a small valve for flushing old grease and contaminants, so check the boot condition on the other side as well.










