Overview
The Mile Marker 95-27997 is a spindle nut conversion kit for front Dana 35 axles. It is used when converting from factory locking hubs to aftermarket locking hubs.
This is a hub conversion kit built around the spindle nut, so check the spindle nut first.
Key features
- Front axle location
- Dana 35 axle type
- Spindle nut conversion design
- Converts factory locking hubs to aftermarket locking hubs
Choosing aftermarket locking hubs
Aftermarket locking hubs come in several designs, and a spindle nut kit has to match the hub you install. Before buying, identify the hub style on your axle and confirm the spindle nut thread and size are compatible. Mixing a spindle nut from one design with hubs from another can leave the hub loose or hard to engage.
Front axles carry steering and drive loads, so the hub and spindle assembly should be checked for wear during conversion. Inspect the spindle threads for damage, clean the bearing surfaces, and replace any worn bearing before reassembly. Tighten the spindle nut to the procedure in a service manual, then check that the hub turns freely. After the first trail run, recheck the spindle nut and hub engagement, since new hardware can settle with use.
Specifications
| Brand | Mile Marker |
|---|---|
| Part number | 95-27997 |
| UPC | 758626279972 |
| Axle location | Front |
| Axle type | Dana 35 |
| Kit type | Spindle nut conversion |
Vehicle fitment
This kit is for front Dana 35 axles. Match the axle and hub type by hand before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Converting from factory locking hubs usually means removing the existing spindle nut and hub setup. Check that the spindle nut kit matches your hub type before starting the job.
What’s included
The kit is a spindle nut conversion only. Plan the tools and parts against your installation before starting.












