Overview
The Crown Automotive J5352169 is an outer hub nut for the front outer position. It fits Dana 44 and Dana 30 standard front axles, in the 1974–1986 Jeep J10 and J20 trucks.
The nut holds the outer hub in place on the axle, so the position and axle type must match. It is the outside nut for the front outer position.
Key features
- Outside nut for the front outer position
- For Dana 44 and Dana 30 standard front axles
Hub nut setup and checks
An outer hub nut holds the outer hub on the axle, so it has to be secured and adjusted correctly for the hub to run smoothly. The nut works with the bearing adjustment and any locking parts that go with the hub. If the threads are worn or the nut does not turn freely, the hub may shift or the bearing may load unevenly, which can lead to noise and wear.
Before reinstalling, clean the spindle threads and check them for damage. Use a fresh locking element where one is used, and avoid reusing a nut that shows cracks, stripped threads or rounded flats. Adjust the bearing carefully so the hub turns freely without play. Keep the bearing grease clean and free of grit, since contamination shortens bearing life. Rechecking the nut after the first few drives is a sensible habit on older trucks.
- Stripped or rounded threads
- Cracks in the nut body
- Play in the hub after adjustment
- Nut that does not turn freely
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5352169 |
| Axle location | Front |
| Axle type | Dana 44 or Dana 30 standard |
| Position | Front outer |
Vehicle fitment
It fits the 1974–1986 Jeep J10 and the 1974–1986 Jeep J20. Other Jeep models and Dana axles fall outside this fit. Check the year, model and trim before ordering.
It fits J10 and J20 trucks only. Check the front axle type before ordering.
Installation notes
Confirm the axle is a Dana 44 or Dana 30 standard before fitting, and that the nut is for the front outer position.
What’s included
One outer hub nut.









