Overview
The Lube Locker LLR-D030 is a differential cover gasket for the Dana 30 axle that also fits Dana 25 and Dana 27 axles, and it needs no additional sealant.
A differential cover gasket seals the cover to the axle housing so gear oil stays in. Lube Locker builds this gasket with a steel core that is rubber coated, with its signature full-perimeter elastomer beading on both sides.
Its full-perimeter beading is built so the gasket does not split or extrude during installation, and it holds torque well. Installation is dry, with no sealant and no set-up time, so there is no RTV silicone mess.
Key features
- Fits Dana 30, and also Dana 25 and Dana 27 axles
- No additional sealant needed
- Elastomer beading on both sides of the gasket
- Steel core, rubber coated
- Full-perimeter beading designed not to split or extrude during installation
- Dry installation with no set-up time
Gear oil and cover care
Differential covers keep gear oil in and dirt out, and the gasket is the seal that does most of that work. Over time heat, pressure and old sealant can flatten or harden a gasket, so a cover that weeps around the bolts is often the first sign of wear. Check the cover and housing for oil on the outside after every service and after deep water crossings.
Gear oil is part of the seal too. Fill to the correct level, use the oil type your axle calls for, and check the drain plug for leaks after refilling. Inspect the pinion seal and axle seals while the cover is off, since replacing them at the same time avoids a second teardown.
- Clean the mating surfaces before reassembly
- Check the drain and fill plugs for leaks
- Replace worn bolts with matching hardware
Specifications
| Brand | Lube Locker |
|---|---|
| Part number | LLR-D030 |
| UPC | 859167006000 |
| Product type | Differential cover gasket |
| Primary axle | Dana 30 |
| Also fits | Dana 25 and Dana 27 axles |
| Axle location | Front and rear |
| Listed axle types | Dana 25, Dana 27, Dana 28 IFS, Dana 30 JK, Dana 30 Reverse, Dana 30 Standard, Dana 30 TJ, Dana 30A KJ |
| Core | Steel core, rubber coated |
| Sealing | Elastomer beading on both sides, no sealant needed |
| Axle manufacturer | Dana |
| Fitment type | Universal fit |
Vehicle fitment
The LLR-D030 matches Dana axles rather than specific vehicles. It is for the Dana 30 and also fits Dana 25 and Dana 27 axles, as well as Dana 28 IFS and several Dana 30 variants. Confirm the axle type in your vehicle before ordering.
Confirm that the axle in your vehicle is one of the listed Dana axle types and that the cover shape matches before installing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Differential cover work is simple but messy. Keep a drain pan under the housing and follow the proper procedure for your axle.
- Use fresh gear oil when refilling the differential, and check the cover for leaks after the first drive.
- Compare the gasket with your cover shape before removing the old one.
- Clean the cover and housing mating surfaces thoroughly before installing, and tighten cover bolts evenly to the specified torque.
What’s included
- Differential cover gasket









