Overview
The Jeep 52059912AC is an upper spring isolator for the 2007–2018 Jeep Wrangler JK. It is a factory style replacement part, sold individually, and it sits at the top of the coil spring to cushion the spring seat.
It fits 2-door and 4-door JK models and mounts in the upper position. Because it is a factory style replacement, it is designed to match the original part rather than change the suspension height.
Key features
- Upper spring isolator
- Factory style replacement
- Sold individually
- Fits 2-door and 4-door JK models
- Jeep part number 52059912AC
Suspension height and spring seats
The upper isolator sits between the top of the coil spring and its seat, where it absorbs small vibrations and reduces noise. Over time the rubber can compress, crack or harden, which can allow the spring to rattle or seat unevenly. Replacing a worn isolator restores the original seating and helps keep the spring centered.
Isolators do not change suspension height, so they will not add lift or correct sag by themselves. If the vehicle sits lower than expected, check the coil springs and other components instead. When the spring is removed, inspect the seat and isolator together, and make sure the new isolator is placed in the same orientation as the old one.
- Look for cracks, flattening or crumbling rubber
- Check that the spring seat is clean before fitting
- Replace on both sides if both show wear
- Confirm orientation before reinstalling the spring
Specifications
| Brand | Jeep |
|---|---|
| Part number | JEP52059912AC |
| Type | Upper spring isolator |
| Quantity | Sold individually |
| Style | Factory style replacement |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler JK in 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, in 2-door and 4-door form.
Wrangler JL and earlier Wrangler models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The isolator is installed at the top of the coil spring when the spring is removed or replaced. Because it is a factory style part, it should be set in the same position as the original, and the spring seat should be checked after the install.









