Overview
The Crown Automotive rocker panel, part number 700402, is a bare steel passenger side formed plate guard for the rocker area of a Jeep Cherokee (XJ). It is a direct fit that requires cutting or drilling during installation.
Crown Automotive has supplied replacement parts for Jeep vehicles for more than 50 years and offers over 8,000 part numbers, including many factory-discontinued items. The panel is supplied as bare steel and is unfinished.
Key features
- Passenger side rocker panel
- Bare steel formed plate guard
- Direct fit to the listed Cherokee XJ trims
- Cutting or drilling required for installation
- Part of Crown Automotive’s range of over 8,000 part numbers
Before you cut
Cutting or drilling a rocker area is a step that cannot be undone, so measure and mark before any tool touches the body. Check the panel against the rocker opening, the door sill and the body seams, and confirm that the passenger side is the correct side. Look behind the panel for wiring, brake or fuel lines, and body mounts. A dry fit with clamps can show where the panel sits before any holes are made.
Bare steel rusts quickly once the mill finish is removed, so clean the panel and treat the surface right after cutting. Remove any oil and sand the edges smooth, then apply a primer and a chassis paint or rust-inhibiting coating. Edges that will sit against the body are the most likely to rust, so seal them as well. Inspect the rocker area each season, especially where water and mud collect under the door.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 700402 |
| UPC | 848399089233 |
| Type | Formed plate guard, rocker panel |
| Position | Passenger side |
| Finish | Bare steel |
| Fitment type | Direct fit |
| Installation type | Cutting or drilling required |
Vehicle fitment
The manufacturer fitment list covers the 1986-2001 Jeep Cherokee (XJ) with the Base, Briarwood, Chief, Classic, Country, Laredo, Limited, Pioneer, SE and Sport trims. Other Jeep generations are not on that list.
This fitment does not cover Wrangler (YJ or TJ), Grand Cherokee (ZJ or WJ) or Comanche models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling, so mounting locations and any trimming need to be planned before the panel is fitted. The finish is bare steel, so the owner decides on any paint or coating after installation.









