Overview
The G2 Axle and Gear 2-2041-456 is a 4.56 ratio ring and pinion for the Toyota 8 Inch axle. The pinion turns 4.56 times for each full turn of the ring gear, a numerically high ratio that multiplies engine torque at the wheels and suits larger tires.
This 4.56 set is made for the Toyota 8 Inch axle in front or rear positions and is built for oversized tires and high-performance engines. Confirm the housing and its location on your vehicle before buying.
Key features
- 4.56 gear ratio for the Toyota 8 Inch axle
- Available for front and rear axle locations
- Ring gear and pinion supplied together
- Built for oversized tires and high-performance engines.
- Current manufacturing methods and materials.
Break-in and gear contact
A new ring and pinion set needs a gentle break-in before it takes full loads. Light throttle, varied speeds and avoiding hard towing during the first stretch of driving let the tooth faces wear in evenly. A gear shop will usually check contact patterns with marking compound before the cover goes on.
Watch for whine that changes with speed or load, a clunk when shifting between drive and reverse, and fluid with metal flakes. Any of these signs justify a prompt inspection. Re-check the cover bolts and carrier fasteners after the first few trail runs, since they can loosen as the new parts settle.
- Check fluid level after the first few runs
- Inspect the drain plug for fine metal debris
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2041-456 |
| UPC | 631410094305 |
| Axle type | Toyota 8 Inch |
| Axle location | Front or rear |
| Gear ratio | 4.56 |
| Axle manufacturer | Toyota |
Vehicle fitment
The set is made for the Toyota 8 Inch axle in front or rear positions. Verify the housing, location and carrier on your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 4.56 gear set needs accurate tooth contact and carrier preload, and a gear shop with setup tools is the usual route. Break the new gears in before heavy loads.
What’s included
One 4.56 ring and pinion set for the Toyota 8 Inch axle, part number 2-2041-456.
Not included: Carrier bearings and shims are not included with the 4.56 Toyota set.
















