Overview
The G2 GM 8.5-inch and 8.6-inch 10 bolt ball milled aluminum cover (part number 40-2021MB) is a rear differential cover for GM 8.5-inch and 8.6-inch 10 bolt axles only. It is cast from lightweight aluminum and finished in black powder coat.
The ball milled ribs add rigidity and help the cover shed heat from the gear oil. The cover is heat treated and shot peened to handle direct impact, and the seal surface is fully machined for a tight fit.
Differential covers of this kind hold the gear oil for the ring and pinion, so the plugs and dipstick are the service features that matter for routine fluid checks on a rear axle.
Key features
- Ball milled reinforcing ribs for rigidity and strength
- Cast from lightweight aluminum to dissipate heat
- Black powder coat finish
- Convenient filler plug for easy service
- Fill-level plug for accurate fill level
- Drain plug for mess-free service
- Easy-to-use dipstick for simple maintenance
Gear oil and differential covers
A differential cover does three jobs: it holds the gear oil around the ring and pinion, it shields the gears from road debris, and it gives the axle housing a clean, sealed face. Gear oil breaks down with heat and time, so the cover’s ability to shed heat and keep the oil contained matters for long-term axle life. Fluid level and condition should be checked on a regular basis, especially after off-road use or towing.
When reinstalling a cover, the gasket or sealant and the sealing surfaces are the main points of failure. Clean both faces thoroughly and remove old gasket material without scratching the housing. Tighten the cover bolts evenly in a crisscross pattern to avoid warping the cover. Check for leaks after the first few drives and re-check the bolts once the axle has run for a while.
- Clean both sealing surfaces before reassembly
- Tighten cover bolts in a crisscross pattern
- Check for leaks after the first few drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 40-2021MB |
| Axle location | Rear |
| Axle types | GM 10 bolt 8.5 inches and GM 10 bolt 8.6 inches |
| Material | Aluminum |
| Oil capacity | Extra capacity |
| Finish | Powder coated, black |
Vehicle fitment
This is an axle part, sized for GM 8.5-inch and 8.6-inch 10 bolt rear axles. The cover is written for the axle, not a vehicle, so match the axle size before ordering.
Installation notes
The cover has a fill-level plug, a drain plug and a dipstick, so the gear oil level can be checked and changed without removing the cover. Confirm the axle size before fitting, since the cover is not made for other GM axles.




























