Overview
The G2 Dana 44 HD Track Bar Bracket, part 68-2052-4, is a rear track bar bracket for the 2007 to 2018 Jeep Wrangler JK with a Dana 44 rear axle. G2 Axle and Gear designs it for use with the G2 rear axle truss and armor system, and it is built for 2-door and 4-door models.
The main components are 1/4-inch thick, with 1/8-inch reinforcement plates. Each part is laser cut to specification for a fit that G2 says makes installation straightforward. The bracket is unpainted, and welding is required to install it.
Key features
- Heavy-duty steel construction
- 1/4-inch main components and 1/8-inch reinforcement plates
- Laser cut components
- Designed for the G2 rear axle truss and armor system
- Unpainted finish
Welding and axle truss planning
A track bar bracket works with the rest of the rear suspension, so its position affects axle centering and steering geometry. Before welding, confirm the bracket sits square to the axle housing and that the frame mounts are clean and free of rust. Mark the layout with a level and tape measure, then tack weld and check alignment before making the final welds.
Welds on a Dana 44 bracket carry constant load from axle movement, so plan for good penetration and full-length beads rather than spot welds. Cracks near the weld toes are the usual early sign of a problem. Paint the bracket after welding to protect the steel, and inspect the welds after the first few trail outings. If you are unsure of your welding skills, have a shop with experience on axle components do the job.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 68-2052-4 |
| UPC | 631410123258 |
| Axle location | Rear |
| Axle type | Dana 44 |
| Steering ram mount | Without steering ram mount |
| Material | Heavy-duty steel, 1/4-inch main parts, 1/8-inch plates |
| Finish | Unpainted |
| Body style | 2-door and 4-door models |
Vehicle fitment
This bracket fits the 2007 to 2018 Jeep Wrangler JK with a Dana 44 rear axle.
The bracket is described only for the JK, so other Wrangler generations are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required. G2 strongly recommends professional welding skills, because the bracket is designed to be used with the G2 rear axle truss and armor system.
What’s included
The rear heavy-duty track bar bracket for the Dana 44 axle.
Not included: the G2 rear axle truss and armor system, which the bracket is designed to work with.








