Overview
The Artec Industries TJ3013 is a raised track bar bracket for the front Dana 30 axle on 1997–2006 Jeep Wrangler TJ and 2004–2006 Wrangler LJ models. It replaces the factory track bar bracket and raises the mounting point, which Artec says adjusts roll center higher for greater stability.
The bracket is meant for setups with crossover or high steering. After a steering change, the track bar has to be matched so it runs parallel to the draglink, and three holes of adjustment give several options to find that geometry. It attaches to the axle next to the factory coil perch.
Key features
- Precision CNC cut and bent 1/4 inch mild steel for a heavy duty fit
- Three raised track bar holes for adjusting geometry
- Designed for crossover or high steering on the front axle
- Raises the roll center for greater stability.
- Works with an Artec truss
Setting up the track bar
A track bar keeps the axle centered under the body as it moves up and down. On a Dana 30 front axle, the bar’s length and angle decide how much side-to-side movement the axle can make, and a raised mount changes that angle. Shorter or raised setups are often chosen by owners running crossover or high steering, where the stock bar sits too low to keep the axle controlled.
Because the bar’s geometry changes with the bracket, the track bar usually needs to be shortened, lengthened or built to suit. Check that it runs close to parallel with the draglink once the steering is set, and recheck after any change to the steering or axle. Expect to adjust the bar in several steps before the ride feels right.
- Confirm the Heim joint or bushing type before building the bar
- Recheck bar angle after a steering change
- Inspect welds regularly on a welded bracket
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | TJ3013 |
| UPC | 816791024305 |
| Material | 1/4 inch mild steel |
| Axle | Front Dana 30 |
| Adjustment | 3 raised track bar holes |
| Joint width | 1.65 inch |
| Type | Axle side |
| Mounting | Welding required, not bolt-on |
Vehicle fitment
It covers 1997–2006 Jeep Wrangler TJ and 2004–2006 Wrangler LJ models with the front Dana 30 axle. It does not cover the 2007–2018 Wrangler JK or other generations. Confirm your vehicle’s year, model and trim before ordering.
It does not cover the 2007–2018 Wrangler JK or other generations. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so this is not a bolt-on part. The bracket runs slightly shorter, so the track bar will need to be modified or fabricated to fit. Joint width is 1.65 inch; Artec suggests its Narrow Misalignment Spacers with 7/8 inch Heims if you build your own track bar. Expect some trial and error to find the ideal ride. Weld only with proper equipment and training.
What’s included
Confirm the package contents match your installation plan before starting. Not included: a track bar, which must be modified or fabricated to suit the shorter bracket, and the welding equipment needed to install it.



