Overview
The TeraFlex 1954886 is a rear trackbar axle bracket kit for Jeep Wrangler JK models from 2007 to 2016, including Rubicon and Unlimited versions. It is built for 2.5 inch lifts and gives the rear track bar multiple mounting locations for neutral lateral alignment of the rear axle.
The bolt-on bracket mounts to the rear axle. It is designed to restore factory-style handling and the correct roll center for a lifted JK, which reduces rear body roll tendencies. The kit is for 2 and 4-door models and right hand drive models.
Key features
- Multiple mounting locations for neutral lateral alignment of the rear axle
- Restores factory handling and correct roll center
- Designed for 2.5 inch lifts
- Bolt-on bracket mounts to the rear axle
- Suitable for 2 and 4-door models
Welding and final fit
Bolt-on brackets are often finished with welding to add strength at the mount. Welding a suspension bracket changes how the load is carried, so the weld should be done by someone with appropriate experience. Clean the surfaces well before welding and confirm the bracket sits square to the axle first.
Trackbar brackets work with the track bar, springs and axle housing as one system. After welding, check that the track bar moves freely through its range and that the bracket does not contact nearby parts. Recheck bolts and welds after the first off-road trips, and inspect them periodically for cracks around the weld.
- Test-fit before final welding
- Check track bar clearance after installation
- Look for cracks near welds during service
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1954886 |
| UPC | 843885032328 |
| Mounting location | Rear axle |
| Type | Axle side |
| Lift height | 2.5 inch |
| Body style | 2 and 4-door models |
| Drive configuration | Right hand drive models |
Vehicle fitment
It fits right hand drive Jeep Wrangler JK models from 2007 to 2016, including Rubicon and Unlimited versions.
Left hand drive JK models, and 2017 and 2018 JK Wranglers, fall outside the stated range. TJ, LJ and JL Wranglers are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is recommended for the final installation, so plan for that step once the bracket is bolted to the rear axle. Set the mounting location to match your 2.5 inch lift before welding.









