Overview
The G2 Raised Height Track Bar Bracket, part number 68-2051-3, moves the track bar mounting point on the front axle of a 2007-2018 Jeep Wrangler JK. G2 makes it for the JK Dana 30 and Dana 44 front axles, and it adjusts the factory track bar mounting location for lifted applications.
The bracket is formed from heavy-duty steel, laser cut from 1/4-inch thick steel for a precise fit, and it ships unpainted. Installation requires welding, and some grinding may be necessary, so this is not a bolt-on part.
A track bar keeps the front axle centered under the vehicle. When a lift changes where the factory mount sits, a bracket like this moves the track bar back to a usable position. The version listed is without a steering ram mount.
Key features
- Heavy-duty steel construction
- Formed from 1/4-inch laser cut steel
- Adjusts the factory track bar mounting location for lifted applications
- Fits the 2- and 4-door JK Wrangler front axle
- Unpainted
Track bar geometry after a lift
A track bar keeps the front axle centered under the vehicle, so when a lift moves the factory mount, the axle can shift sideways under load. A bracket that relocates the track bar back toward a usable position helps restore that centering and reduces steering wander.
Set the new bar location with the axle at the ride height you plan to run. Check the bar bushings and ends for wear before welding, since loose parts can cause the axle to move as the suspension cycles. Make sure the track bar has clearance from the oil pan, drag link and exhaust through full travel.
Alignment is part of the job. Changing the track bar location shifts the front axle position, so have the front end aligned once the bracket is in place and the weld has cooled.
- Check bushings and track bar ends before welding
- Confirm clearance to the drag link and exhaust
- Set the ride height before marking the bracket position
- Have the alignment checked after installation
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 68-2051-3 |
| UPC | 631410121223 |
| Material | Heavy-duty steel |
| Material thickness | 1/4 inch, laser cut |
| Finish | Unpainted |
| Axle location | Front |
| Axle type | Dana 30/44 |
| Steering ram mount | Without |
| Fitment | Direct fit |
Vehicle fitment
The bracket is for the JK Dana 30 and Dana 44 front axles, which covers the 2007-2018 Jeep Wrangler JK. Axle type alone does not set the fit, so the JK model and years define it. Confirm your vehicle’s year, model and trim before ordering.
The Wrangler JL (2018-2022) is a separate model and is not covered by this JK bracket. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, and grinding may be needed to get a precise fit. G2 strongly recommends professional welding skills. Because the track bar location changes, have the front alignment checked after the bracket is installed.
What’s included
The track bar bracket.
Not included: A steering ram mount, which this version is listed without.

























