Overview
The Crown Automotive 52853431AA is a stock-length, non-CV front drive shaft for Quadradrive equipped Jeep vehicles. It is made for the 2007–2010 Jeep Grand Cherokee (WK), including the Laredo, Limited, Overland and SRT8 trims, and the 2007–2010 Jeep Commander (XK).
The shaft is a direct-fit replacement for the front driveshaft position. Its specifications say it does not require a slip yoke eliminator, and the design is non-CV.
Key features
- Front drive shaft at stock length
- Non-CV design
- Designed for Quadradrive equipped vehicles
- No slip yoke eliminator required
- Direct fit to the listed WK and XK models
Quadradrive and driveline matching
A front drive shaft carries power from the transfer case to the front axle, so its length and joint type have to suit the angle and spacing of the driveline. A stock-length shaft keeps the original geometry, which helps the drivetrain run smoothly at highway speeds. Because this shaft is non-CV, it relies on the yokes and u-joints at each end, so their condition matters as much as the tube itself.
When a front shaft is replaced, check the transfer case output yoke and the axle pinion yoke for wear, since a worn yoke can cause vibration even with a new shaft. Look at the rear shaft too, and replace it if it shows play, cracks or leaking seals, because the two shafts work together in the driveline. Tighten all fasteners to the specified values after the first trip and check them again after off-road use.
- Check transfer case and axle yokes for wear
- Inspect u-joint caps for play and grease leaks
- Confirm the driveline angles after the shaft is fitted
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52853431AA |
| UPC | 849603014942 |
| Length | Stock |
| Joint type | Non-CV |
| Position | Front |
| Drivetrain | Quadradrive |
| Slip yoke eliminator | Not required |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2010 Jeep Commander (XK) and the 2007–2010 Jeep Grand Cherokee (WK).
The list does not include the Grand Cherokee WJ or ZJ, or the 2011 and later WK. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One front drive shaft.








