Overview
The Fabtech FTS24155 is a front hydraulic bump stop from the Dirt Logic 2.25 line. It mounts in the factory bump stop position and cushions hard compression impacts on the front suspension.
Fabtech built it for aggressive off-road driving. It replaces the stock bump stop, so it is a direct swap rather than an add-on. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Hydraulic design for controlled compression damping
- Mounts in the OE position
- Built for aggressive off-road use
Before you buy
A front bump stop works only at the end of suspension travel. It becomes the last point of cushioning when the axle compresses hard over rough ground, so its job is to limit impact rather than control everyday ride. Because it sits in the factory position, fit depends on the mount location and the clearance around the axle and nearby components, not just on the stop itself.
Before removing the old stop, look over the factory bracket and surrounding hardware. Bent brackets, cracked welds and corroded fasteners are common reasons a replacement sits badly or loosens under load. Clean the mounting area thoroughly so the new unit seats squarely against it.
- Inspect the mount for cracks and corrosion
- Check clearance at full compression
- Re-check fasteners after the first few trail runs
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABFTS24155 |
| Product type | Front hydraulic bump stop |
| Position | Front, OE position |
| Line | Dirt Logic 2.25 |
Vehicle fitment
It mounts in the factory front bump stop position. Confirm the mount location matches your front suspension before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This stop is designed to replace the factory bump stop, so the factory unit is removed first. Confirm the mounting bracket and clearance with Fabtech before installing.
What’s included
Check the package contents, including hardware and dimensions, against your installation before starting.










