Overview
The Fabtech FTS98000 is a .75 inch heim joint, a right-hand threaded Teflon heim end offered as a single unit for specialty fabrication. It is a rod end for custom linkage builds.
It has a 3/4 inch – 16 shank and a 3/4 inch bore. Fabtech lists Universal Fit, so it is not tied to a particular vehicle.
Key features
- Right-hand threaded Teflon heim end
- 3/4 inch – 16 shank
- 3/4 inch bore
- Universal Fit, Fabtech part number FTS98000
Teflon heim ends in fabrication
A Teflon-lined heim end is a common choice where a joint needs smooth movement without grease. The liner reduces friction between the ball and the housing, which helps the joint pivot freely as the suspension moves. Liners wear over time, so the joint should be checked for play during routine inspection rather than left until it fails.
When designing a link, consider the load direction and the angle the joint will see in use. A joint that runs near its maximum angle will wear faster, so give it room in the layout. Pair the heim end with tubing sized to its shank, and avoid bending the tube after it is threaded in, since bent tubing puts side load on the liner.
- Check for play at each service interval
- Give the joint room to reach its full angle
- Avoid side loads from bent tubing
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS98000 |
| UPC | 674866011298 |
| Shank | 3/4 inch – 16 |
| Bore | 3/4 inch |
| Thread direction | Right hand |
| Fitment | Universal Fit |
Vehicle fitment
Fabtech gives Universal Fit for this heim joint, so it is not matched to a specific vehicle or year.
No vehicle years, models or chassis codes are stated. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Right-hand threads tighten clockwise, so confirm the mating link or tube is also right-hand threaded before assembly.
What’s included
The joint ships as a single unit. Plan on a jam nut or other locking hardware separately if your build requires one.









