Overview
The DrawTite 41933 is a Class V Ultra Frame rear receiver hitch for the 2006–2008 Ford F-150, the 2006–2008 Lincoln Mark LT and the 2007–2012 Toyota Tundra. It is rated for 10000 lbs gross trailer weight and 1000 lbs tongue weight, with weight distributing ratings of 12000 lbs and 1200 lbs. The 2 inch by 2 inch receiver opening accepts 2 inch receiver accessories.
The Ultra Frame design uses all-welded construction and is built to fit the specific vehicle without adapters. It installs with no drilling and takes 20 minutes. Every DrawTite hitch carries a nationwide lifetime warranty.
Key features
- Class V weight rating
- 10000 lbs gross trailer weight rating
- 12000 lbs gross trailer weight distributing rating
- No drill required
- Install time listed at 20 minutes
- All-welded construction built without adapters
- Nationwide lifetime warranty
Choosing a weight rating
The gross trailer weight rating is the total weight the hitch can handle, but the truck’s own towing capacity usually sets the real limit. A hitch rated well above what the truck can pull does not make the vehicle capable of towing more. Compare the trailer’s loaded weight and tongue weight against both figures before you hook up, and keep the load within whichever number is lower.
Weight distribution equipment spreads trailer load across the axles and frame, so the higher weight distributing ratings apply only when a compatible system is used. Frame-mounted hitches are often paired with a sway control bar, a brake controller and a heavier-duty ball mount, since those parts carry the same loads. Inspect the frame attachment bolts and welds regularly, especially after rough towing.
Specifications
| Brand | DrawTite |
|---|---|
| Part number | 41933 |
| UPC | 58914500406 |
| Position | Rear |
| Weight class | Class V |
| Receiver size | 2 inches x 2 inches |
| Gross trailer weight | 10000 lbs |
| Tongue weight | 1000 lbs |
| Weight distributing rating | 12000 lbs GTW / 1200 lbs tongue |
| Construction | All-welded |
| Fitment type | Direct fit |
| Fits with roll pan | No, does not fit with a roll pan |
| Install time | 20 min |
Vehicle fitment
The list covers the 2006–2008 Ford F-150 in FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, STX, XL and XLT trims, the 2006–2008 Lincoln Mark LT in Base trim, and the 2007–2012 Toyota Tundra in Base, Limited and SR5 trims.
The hitch fits the 2006–2008 Ford F-150 in FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, STX, XL and XLT trims, the 2006–2008 Lincoln Mark LT in Base trim, and the 2007–2012 Toyota Tundra in Base, Limited and SR5 trims. Ford F-150 model years 2009 and later, Lincoln Mark LT trims other than Base, and Toyota Tundra model years 2013 and later are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The hitch needs no drilling and takes about 20 minutes to install. Check that the frame attachment points on your truck match the hitch before fastening anything. Support the truck on jack stands while working underneath.
What’s included
Confirm the included fasteners against your installation plan before starting.
Not included: trailer ball, ball mount, and wiring harness need separate parts.














