Overview
The DrawTite 65014 is a front mount receiver hitch with a 2 inch by 2 inch receiver opening for 1992 to 1996 Ford F-250 and F-350 pickups. Its front position gives these trucks a square receiver for accessories mounted at the front of the frame, a location a rear trailer hitch cannot reach.
The hitch is a frame mount design, built with all welded construction to fit the specific vehicle without adapters. Every DrawTite hitch carries a nationwide lifetime warranty.
Key features
- Front position receiver with a 2 inch by 2 inch opening
- Frame mount design
- All welded construction with no adapters
- 500 lbs. tongue weight, weight carrying
- 9000 lbs. maximum gross trailer weight, weight distribution
- Direct fit to the listed Ford F-250 and F-350 trucks
Front accessories and frame mounts
Frame mount receivers bolt to the frame rails rather than the bumper, so the strength of the mounting points matters more than the receiver tube. Before adding accessories, inspect the frame around each bolt for rust, cracks or distortion, and check that the fasteners sit square against the frame.
Front receivers commonly carry winch carriers, light bars and brush guards. Heavier accessories shift the balance of the front end, so check steering response and brake feel after installing. When removing a front accessory, clean the receiver tube so dirt does not wear the pin hole.
Ball mounts and tow accessories are sized to the receiver opening, so the 2 inch receiver size should match the pin and mount you choose. Vibration on older trucks loosens fasteners, so re-check all bolts after the first few trips over rough ground.
Specifications
| Brand | DrawTite |
|---|---|
| Part number | 65014 |
| UPC | 16118069938 |
| Position | Front |
| Mount type | Frame mount |
| Receiver size | 2 inches x 2 inches |
| Fitment | Direct fit |
| Roll pan compatibility | Does not fit with roll pan |
| Weight class | Not rated |
| Tongue weight | 500 lbs. |
| Maximum gross trailer weight | 9000 lbs. (weight distribution) |
Vehicle fitment
The manufacturer fitment list names 1992 to 1996 Ford F-250 and 1992 to 1996 Ford F-350 pickups, with trims Custom, Eddie Bauer, Special, XL, XLT and XLT Lariat.
The hitch fits the 1992 to 1996 Ford F-250 and F-350 pickups only. F-150 and other Ford models are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Confirm which bolts and brackets you have before installing.
Not included: a ball mount and hitch ball sized for the 2 inch receiver opening.














