Overview
The DrawTite 75506 is a Class III/IV rear max-frame trailer hitch for the 2006–2008 Ford F-150 and the 2006 Lincoln Mark LT. Its 2 inch by 2 inch receiver is rated at 6000 lb gross trailer weight and 600 lb tongue weight, or 10000 lb and 1000 lb with weight distribution.
The hitch is built for vehicles without a factory-installed receiver, so check the truck’s current hitch setup before ordering.
Key features
- Class III/IV rating with 6000 lb GTW and 600 lb tongue weight
- Weight distribution rating of 10000 lb trailer weight and 1000 lb tongue weight
- 2 inch by 2 inch receiver opening
- Max-frame design built without adapters.
- Designed for trucks without a factory-installed receiver
- DrawTite says every hitch in its line carries a nationwide lifetime warranty
Factory receivers and setup
A max-frame hitch depends on the frame rails and rear crossmember to carry tow loads, so inspect those areas before fitting. Look for rust, bends or cracked welds, and confirm that the mounting points line up with the hitch. Clean and inspect these areas before bolting anything in place.
Weight distribution equipment can raise the usable rating, but it requires matching components on the ball mount and trailer. Check the ball, pin and clip before each trip, and inspect the bolts and welds after the first few tows. Support the truck safely when working underneath, and keep the trailer’s loaded weight within the rated limits.
- Check frame mounting points for rust before installing
- Recheck bolts after the first few tows
- Replace worn pins, clips and ball mounts
Specifications
| Brand | DrawTite |
|---|---|
| Part number | 75506 |
| UPC | 742512755060 |
| Hitch class | Class III/IV |
| Receiver size | 2 inch x 2 inch |
| Position | Rear |
| Gross trailer weight (GTW) | 6000 lb |
| Tongue weight | 600 lb |
| Weight distributing trailer weight | 10000 lb |
| Weight distributing tongue weight | 1000 lb |
| Factory receiver | Built without a factory-installed receiver |
| Roll pan compatibility | Does not fit with roll pan |
Vehicle fitment
It fits the 2006–2008 Ford F-150 in FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, STX, XL and XLT trims, plus the 2006 Lincoln Mark LT in Base trim.
F-150 model years outside 2006–2008 are not on this list, and other Lincoln Mark models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm that your F-150 or Mark LT has no factory receiver before you start, since the hitch is built for trucks without one. Support the vehicle safely during installation.
What’s included
Check the bolts and brackets you have against the installation steps before starting.














