Overview
The Differential Ring and Pinion Kit from Dana Spicer is a reverse-ratio set for the Dana 44 at a 4.10 gear ratio.
It is a direct fit for Dana 44 axles at a reverse 4.10 ratio.
Before you buy
A ring and pinion kit sets the final drive ratio for the axle, so the ratio you choose changes how the vehicle accelerates, how fast it cruises, and how hard the engine works on the trail. A reverse ratio like this one is usually matched to a carrier and gear type that suit the build, so confirm the match before the housing is opened. Gear sets are rarely the only part worth looking at during a regear.
Bearings, pinion shims, crush sleeves and carrier shims are often replaced in the same job, since they are disturbed when the gears are set. Old bearings with play or pitted races should not be reused. Keep the gear mesh and tooth contact checks as part of the install, and recheck the pinion nut torque after the first few drives.
- Replace the pinion crush sleeve when the pinion nut is loosened
- Inspect carrier bearings for pitting before reuse
- Use fresh gear oil with the correct friction additive
- Recheck pinion nut torque after the first drives
Specifications
| Brand | Dana Spicer |
|---|---|
| Axle type | Dana 44 |
| Gear ratio | 4.10 |
| Gear type | Reverse |
| UPC | 23913127794 |
| Fitment | Direct fit |
Vehicle fitment
No vehicle is named. Confirm the Dana 44 axle and the reverse 4.10 ratio against your carrier before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A ring and pinion set is set up at the carrier, with pinion depth, bearing preload and tooth contact checked before break-in.
What’s included
One ring and pinion kit. Check the bearings and hardware against your installation before starting.








