Overview
The Timken differential bearing race is a single specialty race for Dana 44 differentials that use aftermarket 33 and 35 spline lockers. It is one bearing race only, not a complete bearing set.
Timken makes its bearings from steel, using precision heat treating and precision grinding for a good fit and durability. The race is designed only for the Dana 44 with aftermarket 33 and 35 spline lockers.
Key features
- Single bearing race, not a full bearing set
- Designed for Dana 44 with aftermarket 33 and 35 spline lockers
- Made from steel with precision heat treating and grinding
- Specialty differential race
Checking the gear setup
Differential bearing races sit inside the carrier and support the ring gear and pinion assembly. Their job is to keep the gears aligned under load, both on pavement and on the trail, where torque and shock run higher than in daily driving. A worn or out-of-round race can let the carrier shift, which often shows up as noise, a clunk on throttle changes or uneven tooth contact.
When choosing a race for an aftermarket locker, match the axle housing and locker type first, then confirm the matching bearing fits the carrier. Races are usually replaced in pairs with their bearings, and a new race should not be pressed over a rough or pitted seat. Inspect the bore for scoring before pressing, and have the carrier preload set by someone familiar with the gear set.
- Inspect the carrier bore for scoring before pressing in
- Replace the matching bearing at the same time
- Check gear contact and preload after installation
- Note any whine or clunk after the first trail runs
Specifications
| Brand | Timken |
|---|---|
| UPC | 68203417293 |
| Axle | Dana 44 |
| Locker compatibility | Aftermarket 33 and 35 spline lockers |
| Quantity | One bearing race |
| Material | Steel |
Vehicle fitment
The race is specific to Dana 44 differentials with aftermarket 33 and 35 spline lockers. Confirm fit for your vehicle’s year, model and trim before ordering.
Compare your differential and locker before fitting, because this race is not a general-purpose part.
Installation notes
Race installation generally calls for a press or driver tool and careful seating, so a differential specialist is the usual choice. Seating a race incorrectly can shorten bearing life, so check seating before reassembly.
What’s included
One single bearing race.
Not included: the matching bearing and other bearing race needed to complete the set.









