Overview
The Detroit Locker TrueTrac 913A612 is a limited slip differential assembly for a Toyota 8.4 inch rear axle with 30 splines. It is an all gear driven, clutchless differential that transfers power automatically from the slipping wheel to the non slipping wheel.
The design has no clutches to wear out, which supports long service life in a limited slip differential.
Key features
- Limited slip assembly for a Toyota 8.4 inch axle
- 30 splines
- All gear driven, clutchless design
- Automatic, smooth power transfer from the slipping wheel to the non slipping wheel
- No clutches to wear out
- Rear axle location
Gear setup and break-in
A limited slip differential is only as good as the gear set and the axle it sits in. When a TrueTrac is installed, the ring and pinion pattern and backlash have to be right before the axle carries load. A poor setup can cause noise or early wear no matter how well the differential itself is built. Checking the contact pattern with marking compound is a common step for anyone doing a carrier swap.
Because this unit uses gears rather than clutches, the gear oil does more of the work. Keep the lubricant at the correct level, use the type suited to a limited slip design, and change it on a regular schedule if the vehicle sees water, mud or towing. Listen for chatter in tight turns after installation, since that can point to a fit or lube issue that is simple to fix early.
Specifications
| Brand | Detroit Locker |
|---|---|
| Part number | 913A612 |
| UPC | 70000372212 |
| Part type | Limited slip differential (TrueTrac) |
| Differential type | Limited slip assembly |
| Axle manufacturer | Toyota |
| Axle type | Toyota Tacoma, 8.4 inch |
| Axle location | Rear |
| Axle spline | 30 splines |
Vehicle fitment
It fits a Toyota 8.4 inch rear axle with 30 splines, and the axle type is Toyota Tacoma. Fitment follows the axle rather than a model year, so confirm your vehicle’s year, model and trim before ordering.
Axle size, spline count and gear ratio support matter, so verify them against your own axle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Follow standard axle installation procedures and torque all fasteners to the correct values for your axle. Professional installation is recommended for suspension, steering, brake and axle components. Set the ring and pinion gear pattern and backlash to correct values for your axle, and use the fluid suited to this differential. Re-check fasteners and fluid level after the first miles of driving.








