Overview
The Dana Spicer 36797 is an axle bearing retaining ring with a 2-1/4 inch outside diameter, sold as a factory replacement part. Retaining rings like this hold a bearing in its seat so it stays put during service.
Match the 2-1/4 inch outside diameter and your axle before installing it.
How retaining rings hold bearings
A retaining ring sits in a groove machined into a housing or shaft and holds a bearing or component from moving out of its seat. Because the ring is under spring tension, its fit depends on the groove dimensions as much as the ring itself.
Snap ring pliers are the usual tool for installing and removing these rings. Work carefully so the ring does not twist or fly out, and seat it fully in the groove with the sharp edge facing the correct direction. A ring that is only partly seated can let the bearing shift under load. Inspect the groove for burrs, wear or corrosion before fitting a new ring, and clean the bearing bore thoroughly. Replacing the bearing seal and grease at the same time keeps the assembly working as intended. Mark the position of the ring before removal.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 36797 |
| UPC | 23913256388 |
| Outside diameter | 2-1/4 inch |
| Type | Axle bearing retaining ring |
| Fitment | Universal Fit |
Vehicle fitment
Universal Fit means no specific vehicle is confirmed. Confirm the 2-1/4 inch outside diameter fits your axle before ordering.
What’s included
One retaining ring is included.









