Overview
The Dana Spicer inner axle oil seal, part number 2013455, is an inner seal for an axle housing and carries a Universal Fit label. Confirm the axle type, year, model and trim before ordering.
Because seals are sized to a specific axle, the axle your vehicle uses will decide whether this part is the right one.
Key features
- Inner axle oil seal
- Universal Fit design
- Dana Spicer drivetrain part, part number 2013455
- Dana-backed product line
Seal replacement basics
An inner axle oil seal sits inside the axle housing and keeps lubricant from leaking past the shaft and into the brake area or the bearing. Because it is exposed to heat and pressure from the gear oil, it can harden or wear over time. Leaks often show up as oil on the inside of the wheel or a dark film on the brake backing plate, and a worn seal can let the axle run low on lubricant.
Before pulling the old seal, clean the housing bore and check the shaft surface for grooves, since a damaged surface can cause a new seal to leak quickly. Replacing the seal with the axle partly apart also lets you inspect nearby bearings and the axle shaft. Fill the housing to the correct level after installation and recheck for seepage during the first few drives.
- Clean the seal bore before pressing in the new seal
- Inspect the shaft surface for grooves or pitting
- Replace the gasket or sealant at the housing face if applicable
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 2013455 |
| UPC | 23913137205 |
| Type | Inner axle oil seal |
| Fit listed | Universal Fit |
Vehicle fitment
It carries a Universal Fit label rather than a match to one axle or vehicle, so the axle you have decides whether it is the right seal.
Measure the seal bore and compare it with your axle before installing.
What’s included
Check the package contents against your installation before starting.







