Overview
The Omix-ADA 16536.23 is an axle snap ring for the Dana 30 front axle, supplied as a single piece. It fits the 2002-2006 and 2008 Jeep Liberty (KJ) and is a direct OE replacement built to original specifications, with a limited five year warranty.
A snap ring locates a part on a shaft or in a bore, and this one is meant for the front axle of the Liberty. Because only one ring is in the package, a job on both sides of the axle needs two of the part.
Compare the diameter, thickness and material of the old ring with the new one before installing, and use the part number to confirm the match.
The Liberty (KJ) was Jeep’s compact SUV of the early 2000s, and this ring is part of its front axle assembly. Omix-ADA presents its direct OE replacement parts as built to the original specifications, so the ring is intended to match the one that left the factory.
Key features
- Axle snap ring for the Dana 30 front axle
- Supplied individually, one ring per package
- Fits the 2002-2006 and 2008 Jeep Liberty (KJ)
- Direct OE replacement.
- Limited five year manufacturers warranty from Omix-ADA
Snap ring basics
A snap ring holds a part in a groove, keeping it from walking out of position as the axle turns. On a front axle, it works alongside the seal and bearing to hold the shaft in place. Snap rings need to sit fully in the groove to hold load safely.
A snap ring that has been removed is often bent or stretched, so reusing it is a risk. Check the groove for burrs or wear before installing, and use the right pliers to avoid marking the ring. Fresh gear oil and a check of the bearing should follow the work.
- Do not reuse a bent or stretched ring
- Check the groove for burrs
- Seat the ring fully before assembly
- Inspect the bearing while the axle is open
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16536.23 |
| UPC | 804314134150 |
| _pn | 16536.23 |
| Part type | Axle snap ring |
| Axle | Dana 30 front |
| Quantity | One ring |
| Fit type | Direct fit (Omix-ADA) |
| Warranty | Limited five year (Omix-ADA) |
Check the ring dimensions against the old ring before installing.
Vehicle fitment
It fits the 2002-2006 and 2008 Jeep Liberty (KJ) with a Dana 30 front axle. The fit applies to model and years rather than individual trims.
The manufacturer fitment list for part 16536.23 covers: 2002–2006, 2008 Jeep Liberty (KJ).
Not listed: the 2007 Liberty (KJ), which falls between the listed years, the Liberty built after the KJ generation, and other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Snap rings must be fully seated in their groove. Check that the front axle on your Liberty is the Dana 30 that the part number calls for.
What’s included
- One Dana 30 front axle snap ring









