Overview
The Crown Automotive J8124818 is a tie rod end nut for 1974–1991 Jeep Cherokee, Wagoneer and Grand Wagoneer models. The nut secures a tie rod end stud in the steering linkage.
Confirm the thread size and material against your tie rod end stud before ordering.
Key features
- Tie rod end nut
- Fits Jeep Cherokee, Wagoneer and Grand Wagoneer
- Covers model years from 1974 to 1991
- Direct-fit design
Tightening and checking the nut
A tie rod end nut holds the stud in the steering arm, and it is one of the fasteners that carries steering load every time the wheel turns. Worn threads, a rounded nut or a stud that spins while tightening are signs the joint needs attention before further driving. Inspect the stud threads and the taper before fitting a new nut.
Use a nut that matches the stud thread, and tighten it to the value in the service manual while the stud is held against rotation. Cotter pin holes should line up with the castellations, and a new pin is a sensible replacement. After a few miles of driving, recheck the nut and look for play at the tie rod end.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8124818 |
| Part type | Tie rod end nut |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1974–1983 Jeep Cherokee, the 1974–1990 Jeep Wagoneer and the 1984–1991 Jeep Grand Wagoneer.
Later models, and the 1984-and-newer Cherokee, are not on the list. Confirm your vehicle’s year, model and trim before ordering.









