Overview
The Crown Automotive 83503066 is a rear wheel stud with 1/2 inch thread, made for Dana 44 axles. It fits the 1987 Jeep Cherokee (XJ) and the 1986–1987 Jeep Comanche.
Wheel studs carry the wheel’s load to the hub, so match the thread and axle before ordering.
Key features
- Rear position stud
- Made for Dana 44 axles
- 1/2 inch thread
- Crown Automotive part number 83503066
Matching studs to the axle
Rear wheel studs on a solid axle transfer the wheel load and braking torque through the hub flange, so the stud must match the axle and the hub. Dana 44 axles use a specific stud seat and pattern, and a stud that is wrong for the axle can strip or allow the wheel to move. Check the axle type on the vehicle before buying replacements rather than relying on the year alone.
When fitting a stud, press it fully into the flange so the knurled section bites the hub, and confirm it is seated square with no gap under the head. Inspect the threads for rust or stretching, and replace any stud that spins or shows thread damage. Tighten the lug nuts evenly in a star pattern after installation, and recheck them after the first few drives.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83503066 |
| Position | Rear |
| Axle application | Dana 44 |
| Thread size | 1/2 inch |
Vehicle fitment
It fits the 1987 Jeep Cherokee (XJ) and the 1986–1987 Jeep Comanche.
It is not made for Wrangler models, Cherokee model years after 1987, or other axle types. Make sure your year, model and trim match this fitment before buying.
What’s included
One rear wheel stud, Part Number 83503066.









