Overview
The Crown Automotive 6036482AA is a front wheel stud with a 1/2 in.-20 thread, a .627 in. knurl diameter and a length of 1.938 in. It is made for use with a one piece cast rotor.
It fits 1999–2001 Jeep Cherokee (XJ) and 1999–2006 Jeep Wrangler (TJ) models in the front wheel position.
Key features
- Front position stud
- 1/2 in.-20 thread
- .627 in. knurl diameter and 1.938 in. length
- Described with a one piece cast rotor
Replacing wheel studs
A wheel stud carries the clamping load from the lug nut to the hub, so its thread and knurl must sit tightly in the hub bore. When a stud is pressed out and a new one installed, the knurled section grips the hub, which holds the stud steady while the lug nut is tightened. A stud that spins or has damaged threads should be replaced rather than reused.
Inspect the hub bore for cracks, rust or galling before pressing in a new stud, since a damaged bore can loosen the new stud. Use a stud installation tool or a press to seat it squarely, and avoid hammering that can distort the threads. Check the rotor and hub face at the same time, because a loose stud often comes with a warped or scored mounting surface.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 6036482AA |
| Position | Front |
| Thread | 1/2 in.-20 |
| Knurl diameter | .627 in. |
| Length | 1.938 in. |
| Rotor note | With 1 piece cast rotor |
Vehicle fitment
It fits 1999–2001 Jeep Cherokee (XJ) and 1999–2006 Jeep Wrangler (TJ) models.
It is not made for Cherokee models after 2001 or for Wrangler JK and later models. Review your year, model and trim against this fitment before purchase.
What’s included
One wheel stud, Part Number 6036482AA.









