Overview
The Crown Automotive drag link tie rod end, part number CROJ0999200, is 32-5/16 inch long and has right hand threads. It fits the 1972–1973 Jeep J-2500, J-2600, J-4500, J-4600, J-4700 and J-4800 in Base trim.
It is the right position with right hand threads. Confirm both against the drag link you are replacing.
Key features
- Drag link tie rod end
- Right hand threads
- Right position.
- Overall length of 32-5/16 inch
Choosing a replacement drag link
A drag link carries steering motion from the steering box or pitman arm to the knuckle on the other side, so its outer tie rod end takes constant load through every turn. On older Jeep J-series trucks with a live front axle, the joint moves through a changing angle as the axle travels over rough ground, which is why play at this end is easy to feel through the steering wheel.
When choosing a replacement, match the thread direction and side position to the link being removed, since a reversed end will not sit square in the bar. Compare the overall length with the old unit before buying, and measure center to center between the ball studs if you can. Drag link ends are often replaced alongside the sleeve or bar they thread into, so inspect those parts while the linkage is apart.
Worn ends usually show up as steering play, a clunk over bumps, or uneven front tire wear. Check the rubber boot for tears and grab the stud to feel for movement. Tighten the castle nut to the torque in your service manual and fit a new cotter pin rather than reusing the old one.
- Match thread direction and side position to the removed link
- Inspect the centre link sleeve and bar for wear
- Check the rubber boot for tears and lost grease
- Fit a new cotter pin when reassembling
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | CROJ0999200 |
| Type | Drag link tie rod end |
| Length | 32-5/16 inch |
| Thread direction | Right hand |
| Position | Right |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 1972–1973 Jeep J-2500, J-2600, J-4500, J-4600, J-4700 and J-4800, all in Base trim.
Other years and CJ models fall outside this fitment. Check your year, model and trim against your vehicle before ordering.
What’s included
One drag link tie rod end is described. No other parts are named.









