Overview
The Crown Automotive 52060054AB is a tie rod adjuster link for the knuckle to knuckle assembly on 2 and 4-door models. Crown Automotive makes replacement parts for Jeep vehicles, and this adjuster link is one of them.
Direct Fit is the fitment type, but no years or specific Jeep models are tied to it. Use the part number and the knuckle to knuckle layout of your vehicle to check compatibility before installing.
Key features
- Adjuster link for knuckle to knuckle assembly
- Written for 2 and 4-door models
- Crown Automotive part number 52060054AB
- Direct Fit described by Crown Automotive
Adjuster link alignment
A tie rod adjuster link lets the steering linkage be lengthened or shortened so the wheels can be set to the correct toe. In a knuckle to knuckle layout, it carries steering force between the two wheels, so its ends and threads take considerable stress. Choosing a link means matching its thread direction, length and mounting points to the assembly it joins, since a mismatch can make alignment impossible to hold.
Once the link is in place, set the toe, tighten the jam nuts and clamps to the correct settings, then drive the vehicle to check for pulling and tire wear. Inspect the ends and threads often, especially after off-road work, and replace any link with bent rods, torn boots or thread damage.
- Check the thread direction on both ends
- Match the link length to the existing setup
- Re-check toe after the first few drives
- Replace bent or damaged links rather than straightening them
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52060054AB |
| UPC | 848399038699 |
| Application | Knuckle to knuckle assembly |
| Body styles | 2 and 4-door models |
| Fitment | Direct Fit |
Vehicle fitment
Crown describes Direct Fit for 2 and 4-door models, but gives no years, model names or trims. Use the knuckle to knuckle layout of your vehicle to confirm the link matches.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the mounting fasteners on your existing assembly before installing the link.









