Overview
The Crown Automotive J0642058 is a driver side tie rod tube measuring 17.25 inch and listed in the Left position. It is for the Jeep CJ and Willys line, with fitment listed from 1946 through 1971 across CJ3, CJ5, CJ6 and Willys CJ-2, CJ-3, CJ-5 and CJ-6 models. Its length and end fittings are what to compare first when replacing an early CJ steering tube.
Key features
- Driver side tie rod tube
- 17.25 inch length
- Listed position Left
- Replacement tube for early CJ and Willys models
Working on early CJ steering
A tie rod tube carries steering force from one side of the axle to the other, so its condition matters on any early CJ or Willys build. Before pulling the old tube, mark the position of each end and the clamp orientation so the toe setting can be restored as closely as possible. Look over the rod ends for play, torn boots and rust, because a worn end will keep the new tube from holding alignment for long.
Early Jeep steering often shows years of road grime and seized threads. Soak the fittings, clean the mating surfaces and check that the tube is straight by sighting along it. Tubes that bend or show cracks around the ends should be replaced rather than straightened. After the new tube is in, drive a short test loop, watch for pull or wander, then re-check toe.
- Compare end fittings before ordering
- Inspect rod ends for play
- Clean threads before assembly
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0642058 |
| UPC | 848399052442 |
| Side | Driver side |
| Position | Left |
| Length | 17.25 inch |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1959 Jeep CJ3 (Base), the 1959–1971 Jeep CJ5 (Base) and CJ6 (Base), and the Willys CJ-2, CJ-3, CJ-5 and CJ-6 from 1946 to 1958.
It is not a fit for the CJ7 or any Wrangler model. Before ordering, match your vehicle’s year, model and trim to the application.
Installation notes
Compare the 17.25 inch length and end fittings with the part you are removing before fitting this tube.
What’s included
One driver side tie rod tube. Count the pieces against your installation plan before starting.









