Overview
The Omix-ADA 18044.04 (part number OAI18044.04) is a left-side tie rod end adjusting sleeve for left-hand-drive 2007-2018 Jeep Wrangler JK and JKU models. It is threaded inside and outside, joining the inner and outer tie rod ends so the steering linkage length can be set.
It is a replacement for OE number 52060054AB, with steering and suspension components designed to match the original.
Key features
- Left side position
- Threaded inside and outside
- Replaces OE part 52060054AB
- Direct-fit replacement for 2007-2018 Wrangler JK and JKU
- For left-hand-drive (LHD) models
Setting tie rod length
A tie rod adjusting sleeve controls the overall length of the steering tie rod. Turning the sleeve changes toe, which is the angle of the front wheels viewed from above. Because small changes affect tire wear and straight-line stability, the sleeve should be set with the wheels straight and the steering wheel centered.
Before removing the old sleeve, mark the thread position on each end so you can return close to the original setting. Tighten the jam nuts fully after adjusting, and check that the threads are fully engaged at both ends. Worn tie rod ends or a loose steering box can produce similar symptoms, so inspect those parts too.
- Clean the threads before assembly
- Replace worn jam nuts
- Keep the boots intact to protect the joints
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | OAI18044.04 |
| Part type | Tie rod end adjusting sleeve |
| Position | Left |
| Threads | Inside and outside |
| Replaces OE number | 52060054AB |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2007-2018 Jeep Wrangler JK, covering two-door and four-door Unlimited versions, in left-hand-drive form.
Right-hand-drive vehicles are not covered, and the JL and TJ generations use different parts. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the sleeve sets tie rod length, a wheel alignment is needed after it is fitted or adjusted.
What’s included
One left side tie rod end adjusting sleeve.
Not included: Tie rod ends are not part of this item.









