Overview
The Crown Automotive 68017182AA is an axle shaft universal joint for the front Dana 44 axle of the Jeep Wrangler JK. It fits 4-door models across the 2007-2018 Wrangler JK range. It sits at the front driveshaft-to-axle position and includes clips.
The joint is a direct fit for the Wrangler JK and is not lubeable. Crown Automotive makes replacement parts for Jeep vehicles.
Key features
- Replacement front axle shaft universal joint for the Dana 44
- A direct fit for the Wrangler JK
- Clips included with the joint
- Highway rated
- Not lubeable
Joint replacement and wear
A universal joint at the front axle transfers drive from the driveshaft to the axle while the wheels steer and travel over uneven ground. Worn joints usually show as a clunk when shifting between drive and reverse, a vibration under acceleration, or a click during tight turns. Because the joint is not lubeable, wear is handled by replacement rather than greasing.
When replacing the joint, check the yoke and flange faces for damage and confirm the clips seat fully. Measure the snap ring size against the axle before buying, and inspect the driveshaft for dents that could affect balance. Driveshaft angles affect joint life, so a change in lift or ride height can shorten the joint’s service life.
- Inspect yoke and flange faces for damage
- Confirm the clips seat fully
- Check driveshaft balance after the work
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68017182AA |
| UPC | 848399048117 |
| Position | Front driveshaft at front axle |
| Axle | Dana 44 front |
| Cup size | 1.188 inches |
| Snap ring to snap ring size | 2.500 inches |
| Lubeable | No |
| Highway rated | Yes |
Vehicle fitment
It fits the 2007-2018 Jeep Wrangler JK across a range of trims and body styles.
The 2007-2018 range covers the JK generation, so the TJ, LJ, YJ and JL Wranglers are not covered. The joint is for 4-door models, so 2-door JK owners should check the joint size before ordering. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the snap ring to snap ring size of 2.500 inches against the axle shaft before fitting. Because the joint is not lubeable, check that the retaining clips are seated correctly during installation.
What’s included
One universal joint with clips.








