Overview
The Crown Automotive J0945556 is a manual brake master cylinder for 1967–1971 Jeep CJ5 and CJ6 models and the 1967–1968 CJ5A and CJ6A. It has a dual reservoir and is built for 10 inch brakes.
It is a direct-fit replacement for disc/drum brake setups. The 3/8 inch fitting size matters when matching existing brake lines.
Key features
- Manual brake master cylinder
- Dual reservoir design
- For 10 inch brakes
- 3/8 inch fitting size
- Direct-fit replacement for disc/drum systems
Bleeding and checking the system
A manual master cylinder pushes brake fluid through the lines to the wheel cylinders or calipers. Because the cylinder sits at the firewall with the pedal, any loss of pressure shows up as a soft or low pedal. Replacing it is a good time to check the lines, hoses and wheel cylinders for leaks, corrosion and proper fit.
After installation, bleed the system in the correct sequence to remove air, then check the pedal feel with the engine off and on. Use fresh brake fluid of the type suited to your vehicle, and keep the reservoir topped up during bleeding so air is not drawn back in.
- Inspect brake lines for kinks and corrosion
- Check the boot and pushrod for wear
- Bleed the system until no air bubbles appear
- Replace old fluid rather than mixing
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0945556 |
| UPC | 848399056259 |
| Part type | Manual brake master cylinder |
| Reservoir | Dual |
| Brake size | 10 inch |
| Fitting size | 3/8 inch |
| Type | Replacement |
| Brake configuration | Disc/drum |
Vehicle fitment
It fits the 1967–1971 Jeep CJ5, the 1967–1968 CJ5A, the 1967–1971 CJ6 and the 1967–1968 CJ6A.
Earlier CJ5 and CJ6 years and the CJ7 are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the cylinder has a 3/8 inch fitting size, check that the brake lines on the vehicle use the same size before installing.









