Overview
The Moog K8431T is a press-in front lower ball joint, part number MOGK8431T, for rear-wheel-drive Ford F-150 pickups. It fits the 1996–1997 F-150 in its Base, Eddie Bauer, Lariat, Special, XL and XLT versions.
The joint is for rear-wheel-drive trucks only, so it suits two-wheel-drive F-150s rather than four-wheel-drive models. It has a forged housing and a hardened ball stud. The greasable socket lets fresh grease push contaminants out, and the powdered metal gusher bearing carries grease to the stud. The dust boot with its encapsulated Belleville washer helps control axial and radial movement.
Key features
- Press-in installation into the steering knuckle
- Rear-wheel-drive application only
- Hardened ball stud made of materials Moog says meet or exceed OE specifications
- Powdered metal bearing that moves grease to the stud
- Pre-tapped grease fitting hole and a larger grease reservoir
Choosing a replacement joint
A lower ball joint carries the weight of the wheel and lets the knuckle pivot as you steer, so it takes constant load on and off the road. On a truck driven hard on gravel or washboard, the boot and stud see the most wear. Joint play, a clunk over bumps, or uneven tire wear along the inside edge are common signs that the joint needs attention. Inspect the boot for cracks and check for grease at the fitting before deciding.
Press-in joints need the knuckle removed and the old joint pressed out and the new one pressed in, so plan for that work before starting. Many technicians replace the opposite side at the same time, since both joints have similar mileage. When the upper joint is also worn, replacing both lower and upper joints in one session keeps the front end matching. After installation, have the front alignment checked, because changing a joint alters camber and caster.
- Check the boot for cracks and grease loss
- Plan for press tooling before starting
- Replace matching joints together when both are worn
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGK8431T |
| Position | Front lower |
| Drive type | Rear-wheel drive |
| Joint type | Press-in |
| Lubeable | Yes |
Vehicle fitment
It fits the 1996–1997 Ford F-150 in its Base, Eddie Bauer, Lariat, Special, XL and XLT versions. Four-wheel-drive F-150 models and other Ford trucks are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Four-wheel-drive F-150 models and other Ford trucks are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because it is press-in, the joint needs a press or correct installation tools. Check your truck’s drive type before starting, since this joint is for rear-wheel-drive models only.
What’s included
One Moog front lower ball joint, part MOGK8431T. The joint is supplied as a single front lower unit for the rear-wheel-drive F-150 application named above, so the upper joint and any other suspension parts are separate purchases.










