Overview
The Crown Automotive J0925447 is the outer wheel bearing cup for the front hub on a Dana 30 standard front axle. It fits the 1976-1983 Jeep CJ5, the 1976-1986 CJ7, the 1974-1988 J10 and J20 trucks and the 1981-1985 Scrambler.
A bearing cup is the outer race that the bearing rollers run against. The cup and its matching cone are normally replaced as a pair, so plan on the cone for the same hub.
Key features
- Outer wheel bearing cup for the front hub
- Dana 30 standard front axle application
- Direct fit, Crown Automotive part number J0925447
- Front axle location
Cup and cone pairing
A bearing cup and cone form a matched set. The cup is pressed into the hub and the cone rides on the spindle, with the rollers between them carrying wheel load. Because both parts wear along the same path, a new cup against an old cone can run tight or noisy, so replacing the pair keeps the hub’s preload and contact right.
When the hub is open, inspect the spindle journal, the seal surface and the rollers. Pressing the cup in square prevents a tilted race that can cause early failure. Pack the bearings with grease, set the adjustment as the axle service requires, and recheck the hub temperature after a short drive.
- Replace the cone with the cup
- Check the spindle for scoring or heat marks
- Use a press that keeps the cup square
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0925447 |
| UPC | 848399054798 |
| Part type | Outer wheel bearing cup |
| Axle location | Front |
| Axle type | Dana 30 standard |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1976-1983 Jeep CJ5, the 1976-1986 CJ7, the 1974-1988 J10 and J20 trucks, and the 1981-1985 Jeep Scrambler.
Check the year, model and trim against your vehicle before ordering, especially for Cherokee and Wrangler applications.
Installation notes
Install the cup squarely with a driver or press, and replace the matching cone at the same time.
What’s included
This part is a single outer bearing cup.
Not included: the matching bearing cone, which is needed to finish the hub.









