Overview
The Crown Automotive J5356661 is a front hub bearing with seals for the Dana 30 Standard axle on the 1976–1986 Jeep CJ5, CJ7 and Scrambler.
A front hub bearing supports the wheel hub on the spindle and carries the load of the wheel. This one includes seals and is made for the Dana 30 Standard axle, in the front inner position.
This bearing is a direct fit for the vehicles below. Confirm your vehicle’s year, model and trim before ordering.
On a Dana 30 Standard front axle, the inner hub bearing sits behind the hub and next to the seal. Because the seals are included, a separate inner seal is usually not needed for this bearing. Measure or compare the old bearing and seals before installing.
Key features
- Front hub bearing
- Includes seals
- For the Dana 30 Standard axle
- Front inner position
- Direct fit
Front wheel end care
The front hub bearing carries the weight of the wheel and lets the hub turn freely on the spindle. Its condition affects steering feel, tire wear and noise, so a worn bearing is worth catching early. On a Dana 30 Standard front axle, the inner bearing sits behind the hub and is usually serviced together with the seal that protects it.
Look for a humming or growling noise that changes with speed or turns, play when the top and bottom of the tire are rocked, and grease on the brake parts. These signs point to the bearing, the seal or the preload. Check the bearing race and the spindle surface before fitting a new bearing, because a rough spindle can wear a new bearing quickly.
When repacking or replacing, keep grease and dirt out of the bearing and set preload carefully so the wheel turns freely without play. Deep water and mud can push contamination past a worn seal, so check the seal after water use. Recheck the wheel end after the first few drives.
- Check for play at the top and bottom of the tire
- Inspect the spindle and bearing race
- Keep grease and dirt out during assembly
- Recheck the wheel end after the first drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5356661 |
| UPC | 848399063844 |
| Part type | Front hub bearing |
| Axle | Dana 30 Standard |
| Position | Front inner |
| Includes | Seals |
Vehicle fitment
Crown Automotive’s list for the J5356661 bearing covers:
- 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
Only CJ5, CJ7 and Scrambler years are covered. Wrangler and Cherokee models are outside the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One front hub bearing with seals, part number J5356661.
Not included: the outer bearing and hub hardware.









