Overview
The Crown Automotive J5365082 is a front wheel bearing seal for spindles with a 2.313 inch diameter on the 1976–1986 Jeep CJ5, CJ7 and Scrambler.
A wheel bearing seal keeps grease inside the hub and keeps dirt and water out of the bearing. Seals are sized to the spindle, and this one is made for a 2.313 inch spindle diameter.
This seal is made for the front position, on either the driver or the passenger side, and is a direct fit.
Seals are sized to the spindle, so the 2.313 inch diameter is the dimension to check. A seal that is too large or too small leaks, so measure the spindle or compare the old seal before installing. It is made for front use on the driver or passenger side and pairs with the bearings made for CJ5, CJ7 and Scrambler models.
Key features
- Wheel bearing seal
- For a 2.313 inch spindle diameter
- Driver or passenger side front
- Direct fit
Seal fit and replacement
A wheel bearing seal sits at the outer end of the hub and holds grease around the bearing while keeping water and grit out. Its lip rides against a sealing surface, so both the seal and the surface it contacts matter.
A seal sized to the spindle sits square and seals evenly. Check the spindle for grooves or rust before installing, and clean the sealing surface. A seal that leaks often shows grease on the inside of the wheel or on the brake parts, which means it should be inspected.
Install the seal square and evenly, and keep it clean while pressing it in. Packing the bearing with fresh grease is a good idea whenever the seal is replaced. Check the wheel end after the first few drives, particularly after water crossings.
- Measure the spindle or compare the old seal
- Check the spindle for grooves or rust
- Install square and evenly
- Repack the bearing with fresh grease
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5365082 |
| UPC | 848399065268 |
| Part type | Wheel bearing seal |
| Spindle diameter | 2.313 inch |
| Position | Front |
| Side | Driver or passenger |
Vehicle fitment
It fits the following vehicles:
- 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
Only CJ5, CJ7 and Scrambler years are covered. Wrangler and Cherokee models are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Since the seal is matched to a 2.313 inch spindle, measure the spindle or compare the old seal before installing. A new seal should go in together with freshly packed bearings.
What’s included
One wheel bearing seal, part number J5365082.
Not included: bearings and other hub hardware.









