Overview
The Crown Automotive J3157273 is a side bearing cone for the Dana 27 differential, installed at the front position. Two are required for a full set.
It fits the 1966 Jeep CJ-3, the 1959–1971 CJ-5 and CJ-6, and the 1955–1958 Willys CJ-5 and CJ-6, all in Base trim.
Key features
- Side bearing cone for Dana 27 differentials
- Two are required.
- Position is front.
Before you replace the cones
A side bearing cone sits on the differential case and carries the ring gear load as the carrier turns. Over time the rollers and race wear, which can cause a whine or grinding noise from the axle, play at the carrier, or a ring gear that does not hold steady. When one cone is replaced, the matching cup should be inspected for pitting, grooves or heat marks, since a worn cup will wear a new cone quickly.
Side bearing preload and ring gear backlash are set together, so the carrier is usually pulled and the bearings reset during the job. Shims or adjusters are set to the specification for the axle, and the ring gear should be checked for runout before the carrier goes back in. Replacing both sides at the same time keeps the bearing preload even across the carrier.
- Inspect the cups along with the cones
- Replace bearings in matched pairs when both sides are worn
- Check the package contents before starting the teardown
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3157273 |
| UPC | 848399057959 |
| Axle | Dana 27 |
| Position | Front |
| Quantity required | 2 |
Vehicle fitment
It fits the 1966 Jeep CJ-3, 1959–1971 CJ-5 and CJ-6, 1955–1958 Willys CJ-5 and 1956–1958 Willys CJ-6, all in Base trim.
The list does not include the CJ-7 or the Scrambler.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Two cones are needed. Check the package contents against your installation before starting.









