Overview
The Crown Automotive 5103014AA is a Dana 35 C-clip rear passenger side axle shaft with 27 splines for the 2003–2006 Jeep Wrangler TJ. Crown Automotive limits the 5103014AA to use with axle 52111766F or 52104676AC only, so the first job is to check which axle part number your TJ carries. The shaft is a C-clip design, which means a clip inside the differential holds it in place.
Its attribute list gives the axle type as Dana 35, the shaft location as passenger side and the position as rear right. Crown Automotive classes it as a direct fit for the TJ. Dana 35 rear axles in TJ Wranglers were fitted with several axle assemblies, which is why Crown Automotive restricts this shaft to two axle part numbers. If your axle carries neither 52111766F nor 52104676AC, this shaft is not the one to choose, even if the year and model match the list below. The passenger side is the rear right, and the driver side shaft for the same axle is a separate part. Crown Automotive classes the part as a direct fit, so no modification is expected on a matching TJ.
Key features
- Passenger side rear axle shaft
- C-clip design
- Dana 35 rear axle with 27 splines
- For axle 52111766F or 52104676AC only
- Classed by Crown Automotive as a direct fit
Axle shaft wear signs
Axle shafts carry the torque from the differential to the wheel, and on a Dana 35 they also take side loads when the vehicle turns or crosses uneven ground. A worn or cracked shaft usually shows itself as a clunk when moving off, vibration under acceleration or a wheel that wobbles slightly. Because the C-clip sits inside the differential, check for oil leaks at the axle seal too, since a leaking seal can ruin the bearing that the shaft runs against.
When a shaft is out for service, look closely at the splines for twisting or rounding and inspect the bearing surface for pitting. Replacing a seal at the same time is common practice, and the differential fluid should be checked after the work. Keep the axle number written down before buying, since axle identity is what determines whether a shaft will fit.
- Check the splines for rounding or twisting
- Inspect the axle seal for leaks
- Confirm the axle number before buying
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5103014AA |
| UPC | 848399035513 |
| Axle manufacturer | Dana |
| Shaft location | Passenger Side |
| Axle position | Rear |
| Axle type | Dana 35 |
| Position | Rear Right |
| Spline count | 27 Splines |
| Axle design | C-clip |
| Compatible axles | 52111766F or 52104676AC only |
Vehicle fitment
The 2003–2006 Jeep Wrangler TJ is the covered model, in the 65th Anniversary Edition, SE, Sahara, Sport and X trims.
- 2003–2006 Jeep Wrangler (TJ) (65th Anniversary Edition, SE, Sahara, Sport, X)
Coverage is the 2003–2006 Wrangler TJ and is further limited to the two axle numbers named above. 1997–2002 TJs, the YJ and the JK are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because Crown Automotive restricts this shaft to two axle numbers, read the number on your Dana 35 housing before you remove anything. Being a C-clip shaft, it comes out and goes in with the differential cover and clip handled in the usual C-clip way.








