Overview
The Advance Adapters crossmember mount, part number 716021, is a transfer case mount for the Dana 300 transfer case, used together with Advance Adapters’ adapters. It replaces the factory torque mount with a section of rectangular tubing that Advance Adapters says is cadmium plated, with large bushings and 5/8-inch bolts.
The mount is made from 3-inch by 1-1/2-inch by 1/8-inch rectangular tubing. It fits Wrangler models in the JK, LJ, TJ and YJ generations, covering the years 1987 to 2016.
Key features
- Replaces the factory torque mount
- Made from 3-inch by 1-1/2-inch by 1/8-inch rectangular tubing
- Cadmium plated tubing.
- Large 5/8-inch bolts and large bushings
- Designed to work with Dana 300 transfer cases and Advance Adapters adapters
Transfer case mount wear and setup
A transfer case crossmember mount carries the weight and torque of the transfer case and holds it in position relative to the driveshafts. When the mount sits correctly, the drivetrain stays aligned and the transfer case does not shift under load. Because the factory style mount is being replaced here, the new tubing and bushings take over that job, so the setup needs to be square before the bolts are fully tightened.
Bushings are the parts that usually wear first on a mount like this. Look for cracking, flattening or gaps in the rubber, and check whether the transfer case moves when you apply firm pressure by hand. Movement or clunking during acceleration and braking can point to a worn mount or loose hardware. Re-check the bolts after the first few trail runs, since new bushings can settle.
- Check bolt torque after the first few drives
- Inspect bushings for cracks or flattening
- Look for shifting or clunks under load
Specifications
| Brand | Advance Adapters |
|---|---|
| Part number | 716021 |
| UPC | 808331013306 |
| Product type | Transfer case crossmember mount |
| Works with | Dana 300 transfer case |
| Tubing size | 3-inch x 1-1/2-inch x 1/8-inch rectangular |
| Bolt size | 5/8-inch |
| Finish | Cadmium plated |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007 to 2016 Jeep Wrangler (JK), the 2004 to 2006 Wrangler (LJ) Unlimited and Unlimited Rubicon, the 1997 to 2006 Wrangler (TJ), and the 1987 to 1995 Wrangler (YJ).
Close vehicles that are not on the list include the Wrangler JL and the Wrangler JK from 2017 on. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The mount replaces the factory torque mount, so remove the factory mount first. It is used with the Dana 300 transfer case and its adapters.
What’s included
The kit includes the tubing crossmember, bolts and bushings that make up the mount system. The transfer case adapters are companion parts and are not part of this mount.









