Overview
The Bushwacker Cut-Out Style rear fender flare pair, part 20012-11, is a pair of rear flares for Ford vehicles. Each Cut-Out set is individually designed for the vehicle to maximize off-road wheel travel and maintain adequate tire coverage. This pair adds 3.5 inches of width and tire coverage at the rear.
Cut-Out flares require cutting body sheet metal to reach maximum articulation and coverage for oversized tires. The design gives a smoother appearance and greater strength, and the pair is fastened with a tough rivet installation. It is made in the USA from thick, warp-proof Dura-Flex 2000, and the matte black finish is easy to paint.
Key features
- Individually designed to maximize off-road wheel travel
- 3.5 inches of width and tire coverage at the rear
- Sheet metal removal maximizes wheel articulation
- Tough rivet installation
- Warp-proof Dura-Flex 2000 construction, made in the USA
- OEM matte black finish that is easy to paint
Cutting and rivet install
Rear cut-out flares change the wheel opening, so the work starts before the first cut. Measure the clearance at the tire with the vehicle loaded and at full suspension travel, then mark the cut line with the flare held in place.
The rivet installation is a different step from bolt-on flares, so plan the holes and the rivet positions carefully. Drill and set rivets in the order that keeps the flare aligned, and check the position against the tire after each step.
Cut edges need attention after the install. Deburr them, seal the bare metal with primer and paint, and apply a seam sealer where the flare meets the body. Recheck the rivets after the first wash and after rough trail use.
- Mark the cut line with the flare held in place
- Plan rivet positions before drilling
- Deburr and prime every cut edge
- Recheck rivets after the first wash
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 20012-11 |
| UPC | 90689103154 |
| Position | Rear |
| Quantity | Pair |
| Width and coverage | 3.5 inches |
| Material | Dura-Flex 2000 |
| Finish | OEM matte black, paintable |
| Front pair part number | 20011-11 |
| Warranty | Limited lifetime |
Vehicle fitment
This pair is made for Ford vehicles in general. Confirm fit for your Ford model year, cab and body style before ordering.
Because no years or models are given, do not assume this pair matches a particular Ford truck or SUV. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Cut-Out flares require cutting body sheet metal, and the pair uses a tough rivet installation. Check the fit on your vehicle before cutting, and mark the cut line for your model first.
What’s included
This is the rear Cut-Out pair. The front pair is part 20011-11.









