Overview
The Bilstein 8100 Series 25-304916 is a front right remote reservoir shock absorber for the 2020–2026 Jeep Gladiator. It is a large bore, 60mm direct-fit shock for lifted trucks and SUVs, and it uses eyelet mounts at both ends.
The body is built from aerospace quality billet components. The 60mm inside diameter increases oil volume, which helps control heat while the truck covers rough roads over long distances. The monotube design uses velocity sensitive digressive valve settings tuned for each application.
The reservoir can be remote or piggyback, and installation is straightforward. Mount the reservoir where the hose runs clear of moving parts. The 60mm piston offers more comfort and control in all driving conditions. This part covers the front right position only, so confirm the side before ordering. Compare the installed length of your current front shock and allow room for the reservoir.
Key features
- Front right position
- 60mm large bore body from billet components
- Remote or piggyback reservoir
- Monotube design with velocity sensitive digressive valving
- Eyelet top and bottom mounts
Mounting and hose routing
Mounting a remote or piggyback reservoir takes more planning than a plain shock, because the reservoir must sit where it is protected yet still free to move with the suspension. Choose a spot away from the tire path and the exhaust, and give the hose a smooth bend rather than a sharp kink.
A right-side unit should be matched with its partner on the left, so both front shocks keep the same damping and feel. Before fitting, inspect the bushings, bump stops and springs, since worn parts can make the new shock wear faster. After the first drive, recheck the mounts and hose clamps, because movement on rough ground can loosen them.
- Keep the hose away from heat sources
- Check the reservoir clamp after the first drive
- Look at the bump stops for wear
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 25-304916 |
| Shock series | 8100 Series |
| Position | Front right |
| Shock type | Monotube reservoir |
| Body diameter | 60mm |
| Top mount | Eyelet |
| Bottom mount | Eyelet |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2020–2026 Jeep Gladiator, front right position.
Gladiator models from before 2020, the Jeep Wrangler, and the front left position are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One front right remote reservoir shock absorber.
Installation notes
Check the reservoir and hose clearance on your truck before mounting, and confirm you have the right side before ordering.












