Overview
The Bilstein 5160 Series 25-294316 is a rear remote reservoir shock absorber for the 2019–2023 Ford Ranger. The reservoir is a separate chamber connected to the shock body by a hose, which increases cooling capacity and wheel travel compared with a traditional shock absorber.
The shock is a monotube design, which Bilstein says gives consistent fade-free performance. Its valve settings are velocity sensitive and digressive, and they are tuned for each specific application. Each unit is fitted with a 360 degree swivel banjo hose fitting that Bilstein describes as a clean, low profile installation.
This shock is a direct fit for lifted trucks and SUVs, and the position is rear. Confirm the installed length against the shock you are replacing before ordering, and compare the mounting points at the same time.
Key features
- Remote reservoir for increased cooling capacity
- Monotube design for consistent damping
- Velocity sensitive digressive valve settings
- 360 degree swivel banjo hose fitting
- Rear position
Ranger rear shock setup
On a pickup like the Ranger, the rear shocks work hardest when the bed is loaded or the truck is towing over ground that is not smooth. A remote reservoir gives the oil a larger space to sit in, so the damper is less likely to overheat during a long descent with weight in the back. Owners who tow on hills or drive quickly over washboard gravel will notice the difference.
Before fitting a rear shock on a Ranger, look at the lower eyelet and upper stud, since worn bushings can shift the angle of the damper and wear it unevenly. Route the reservoir hose away from the exhaust, brake lines and the spare tire carrier. If the old shock shows oil on the body, a dented reservoir, or a hose with cracked ends, replace it together with the other rear unit so the pair damps the same way.
- Check the rear bushings for cracks while the shock is off
- Keep the reservoir clear of the exhaust and brake lines
- Tighten the mounts once the suspension is loaded
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 25-294316 |
| Shock series | 5160 Series |
| Position | Rear |
| Shock type | Remote reservoir, monotube |
| Hose fitting | 360 degree swivel banjo |
| Gas charge | Gas charged |
| Fitment type | Direct fit |
Vehicle fitment
It is a rear remote reservoir shock for the 2019 through 2023 Ford Ranger.
Ford Ranger models before 2019, and Ranger-based or other Ford trucks outside this list, are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear remote reservoir shock absorber.
Installation notes
The reservoir hose needs a clear route away from moving parts, so plan where the reservoir will sit before you tighten the mounts.










