Overview
The Bilstein 5100 Series shock absorber, part number 33-151663, is a rear gas-charged monotube shock with a 16 mm lower eye and a bar pin upper mount. It is designed for a 5 – 6 in. lift height. Match the vehicle year, model and trim to the shock before buying.
Bilstein describes its 5100 Series line as a traditional single-tube shock for lifted trucks, Jeeps and prerunners. This non-coilover unit has a 46 mm ID smooth body and a boot included, which Bilstein lists alongside its lift rating.
Key features
- Monotube gas pressure body for consistent damping
- Self-adjusting deflecting disc valving
- High-flow piston intended to reduce harshness
- Independent rebound and compression tuning
- Larger working piston area for control on large tires
- Lift kit design that uses the stock OEM mounting configuration
Bar pin and eye mounts
A bar pin upper mount and a 16 mm eye at the lower end are not the most common combination, so the upper bracket is the first thing to check. The bar pin must sit squarely in its receiver with no side load, or the shock can bind as the suspension moves through its travel.
Lift height and mount geometry go together. A 5 – 6 in. lift changes the angle at which the shock works, so damping and travel are best judged after a trial fit with the truck at ride height. Keep the shaft clear of the frame and the boot clear of brake lines and axle components throughout the range.
- Measure the installed length before tightening
- Check the lower bracket for cracks or elongated holes
- Use a bar pin that moves freely without play
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 33-151663 |
| UPC | 651860604701 |
| Series | 5100 Series |
| Position | Rear |
| Collapsed length | 15.91 in. |
| Extended length | 25.93 in. |
| Travel length | 10.02 in. |
| Lower mount | Eye, 16 mm |
| Upper mount | Bar pin |
| Shaft diameter | 14 mm |
| Body design | 46 mm ID smooth body (non-coilover) |
| Internal design | Mono tube |
| Reservoir | No |
| Boot included | Yes |
| Gas charged | Yes |
| Finish | Zinc plated |
| Fitment type | Direct fit |
| Lift height | With 5 – 6 in. lift |
Vehicle fitment
Its application covers lifted trucks, Jeeps and prerunners in general, not a particular model, generation or year.
Because no application is listed, do not assume a match from the Jeep or truck wording alone. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The upper end is a bar pin rather than an eye, so your upper mount must accept a bar pin. The 16 mm lower eye should also match your existing lower bracket before the shock is fitted.
What’s included
One shock absorber with a boot included. Check mounting hardware needs against your installation before fitting.









