Overview
The 6929272 from Baer Brakes is a right-side replacement rotor measuring 13.85 inch across with a 1.25 inch nominal thickness. Built as a two-piece vented rotor with a stepped flange, it carries a slotted, drilled and zinc-plated finish and is intended for select Baer Brake systems.
The castings are purpose built, with a curved vane design intended to aid cooling. The surface is directional, which makes the rotor specific to one side of the vehicle, so this unit is made for the right side only. Each part number covers one rotor.
Key features
- Two-piece vented cast iron rotor
- Stepped flange mounting design
- Slotted, drilled and zinc-plated finish
- Curved vanes that Baer Brakes describes as optimum cooling
- Built for rotor stability and resistance against distortion
- Dynamically balanced to support vibration-free performance
- Directional surface made for the right side of the vehicle
Stepped flange mounting
A stepped flange rotor sits on a raised shoulder of the hub, so the flange contact faces must be clean and flat for the rotor to run true. Two-piece rotors hold the ring to the hat with fasteners, so those fasteners are part of the mounting and should be checked as carefully as the wheel nuts.
Because the hat and ring are separate, wear can show up at the joint as well as on the friction face. Inspect the fasteners for stretch or corrosion before reuse, and recheck their tightness after the first few drives. Replace any fasteners that look damaged rather than reusing them.
- Clean the hub shoulder and flange contact faces
- Check hat fasteners for tightness after the first drives
- Replace fasteners that show stretch or corrosion
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6929272 |
| UPC | 844165052289 |
| Outside diameter | 13.85 inch |
| Nominal thickness | 1.25 inch |
| Mounting style | Stepped flange |
| Bolt hole circle diameter | 7.5 inch |
| Bolt hole quantity | 12 |
| Rotor type | Two-piece vented |
| Material | Cast iron |
| Surface type | Slotted, drilled and zinc-plated |
| Brake surface | Directional |
| Axle position | Right |
| Grade type | Performance |
| Emission code | 6 |
| ABS tone ring included | No |
| Country of origin | USA |
| Sold as | Each |
Vehicle fitment
It is a replacement for select Baer Brake systems, so the right match depends on your current Baer brake setup. Confirm the systems it covers before ordering.
Confirm your vehicle’s year, model and trim before ordering. Left-side applications are not covered by this right-side rotor.
Installation notes
Fit this rotor to the right side only because its surface is directional. The stepped flange and the 12 mounting holes on a 7.5 inch bolt circle should line up with your hub before the rotor goes on, so measure and compare first. No ABS tone ring is included. Because brake rotors are safety-critical, a qualified technician should install and inspect the assembly.
What’s included
One rotor per part number.
Not included: ABS tone ring.
