Overview
The Baer Brakes 6919173 is a left-side, 1-piece replacement brake rotor with slotted and drilled faces and a zinc-plated finish. It is made for select Baer Brake systems, so match it to an existing Baer setup rather than a named vehicle.
The rotor is full cast from cast iron and vented, with a curved vane design intended for cooling. It measures 13.57 in outside diameter and 1.1 in nominal thickness, with 5 studs and a 3.055 in center hole. It is directional and made only for the left side. With an overall height of 2.15 in, compare it with the rotor being replaced before fitting.
Key features
- Left-side directional rotor, made for the left side of the vehicle only
- Slotted, drilled and zinc-plated surface
- Curved vane design that Baer Brakes describes for cooling
- Full cast, 1-piece construction in cast iron
- Dynamically balanced for vibration-free performance.
- Engineered for rotor stability and resistance to distortion
- Purpose built castings made from premium materials
Before you buy
Brake rotors wear through friction, heat cycling and corrosion, so the faces gradually lose thickness and can develop grooves, heat checks or a lip at the outer edge. Before buying a replacement, measure the old rotor’s thickness and runout, and inspect the hub face and bolt holes for rust or damage. A rotor that has run below its minimum thickness should not be reused, regardless of how the surface looks.
Because this rotor is directional, pair the left-side replacement with the matching right-side part on the other wheel. Brake pads are usually replaced at the same time, since new pads need a clean, flat surface to bed in correctly. Check caliper slide pins and brake hose condition while the wheel is off.
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6919173 |
| UPC | 844165051039 |
| Axle side | Left |
| Outside diameter | 13.57 in |
| Nominal thickness | 1.1 in |
| Overall height | 2.15 in |
| Center hole diameter | 3.055 in |
| Stud/lug hole circle diameter | 5.00 in and 4.50 in |
| Stud/lug quantity | 5 |
| Material | Cast iron |
| Construction | Full cast, 1 piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface type | Slotted, drilled and zinc plated |
| Grade type | Performance |
| ABS tone ring included | No |
| Drum in hat | No |
| Emission code | 6 |
| Package | Each |
| Country of origin | USA |
Vehicle fitment
It is made for select Baer Brake systems. Match it to your existing Baer hub, 5-stud pattern and center bore, and confirm fit for your vehicle’s year, model and trim before ordering.
No vehicle is confirmed for this rotor. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm you are fitting the left rotor, because it is directional and not made for the right side. Baer Brakes does not include an ABS tone ring with this part. The stud pattern is listed at 5.00 in and 4.50 in, so check the stud count and circle diameter against your hub before installation.
What’s included
A left replacement rotor, packaged as each.
Not included: ABS tone ring. Brake pads and calipers are separate parts and are not part of this part number.
