Overview
The Baer Brakes 6911145 is a left-side 13.000 Inch replacement brake rotor with a 1-piece, slotted, drilled and zinc-plated design for select Baer Brake systems. It is a vented, directional rotor with a 5 x 5.50 Inch bolt pattern and a 3.000 Inch register, so confirm the Baer system it is built for before installation.
The casting uses a curved vane design for cooling and is dynamically balanced for vibration-free running. It is made from cast iron with a performance grade. The braking surface is directional, so it is made for the left side of the vehicle only.
Key features
- Full cast, one-piece cast-iron construction
- Slotted, drilled and zinc-plated braking surface
- Curved vane design for cooling
- Directional brake surface built for the left side
- Dynamic balanced for vibration-free performance
- Vented rotor type with five studs
Before you buy
Brake rotors wear through contact with the pads, so the braking surface is the first thing to inspect at each service. Look for deep scoring, heat cracks, a raised lip at the outer edge, and uneven thickness across the face. A rotor that pulses under braking or shows runout beyond the service limit should be measured and replaced rather than resurfaced on the vehicle.
Matching a left rotor takes more than the bolt pattern. The hub, wheel bearing and caliper bracket must suit the system the rotor was built for. Directional rotors also depend on correct orientation, so mark the left and right sides before removal and avoid mixing them during reassembly.
- Replace pads and rotors together when wear is uneven
- Clean the hub face and mating surfaces before mounting
- Torque wheel fasteners in a star pattern after fitting
- Bed in new pads gradually to avoid uneven transfer
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6911145 |
| UPC | 90127961339 |
| Outside diameter | 13.000 Inch |
| Nominal thickness | .810 Inch |
| Overall height | 3 |
| Stud/lug hole circle | 5 x 5.50 Inch |
| Stud/lug hole quantity | 5 |
| Register (center hole diameter) | 3.000 Inch |
| Axle | Left |
| Material | Cast iron |
| Construction | Full cast, one piece |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface finish | Slotted, drilled and zinc plated |
| Drum in hat | Yes |
| ABS tone ring included | No |
| Grade type | Performance |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
It is built for select Baer Brake systems rather than specific vehicles. Before ordering, make sure the year, model and trim of your vehicle match the system it is built for.
Baer names this rotor by its brake system, not by vehicle, so a matching bolt pattern alone does not confirm it suits your vehicle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rotors are sold individually, so a pair needs one left and one right unit. This rotor is the left unit and should not be fitted on the right side. Drum in hat is Yes, so check it against your hub before fitting. Bed in new pads as the pad maker directs.
What’s included
One left-side rotor, sold as Each.
Not included: Pads, calipers, hubs and hardware are not included with this rotor.
