Overview
The Bilstein B8 8100 Series rear left shock absorber, part number 25-269802, is a gas charged shock offered as a direct fit unit. The product name says B8 8100 Series, while the specifications give the shock series as B6 Series, so confirm the series with Bilstein before ordering.
The shock has a 0 in. lift/drop rating. Ride tuning is designed for specific vehicles, and exact tuning values are left out here, so confirm setup for your vehicle before ordering.
Key features
- Rear left position
- Gas charged shock body
- Direct fit design
- Ride tuning designed for specific vehicles.
Matching a shock by part number
When a shock carries a series name that differs from its part number, the part number is the reliable reference. Compare the part number, collapsed and extended lengths and mount style against the shock you are removing. Measuring the old shock before ordering helps avoid a unit that is close in name but wrong in length.
Gas charged rear shocks keep damping steady over repeated use, which helps the rear end control bounce on rough roads. Rear left and rear right units should be replaced as a matched pair so both sides damp the same. Check the lower and upper mounts for cracks while the old unit is off.
- Measure the old shock’s collapsed and extended length
- Compare mount style and bushing size
- Replace rear shocks in pairs for even handling
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 25-269802 |
| UPC | 651860797601 |
| Shock series | B6 Series (product name reads B8 8100 Series) |
| Position | Rear left |
| Fitment type | Direct Fit |
| Lift/drop | 0 in. |
| Charge | Gas charged |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering, and check the mounts against your existing shock.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The series is given inconsistently, so match the part number 25-269802, not the series name, when comparing with your existing shock.
What’s included
Check bushings, mounts and hardware against your existing shock before installing.









